Kingspan® KS1000RW
We are committed to ensuring the quality of our products at every stage in the production process. From initial product design, to prototype testing, through the manufacturing process to final testing and distribution of approved fasteners.
This information is to be used as a reference of the most common fastener to be used in a specific system.
KS1000 RW fixing to steel substrate 1.2 - 4.0mm
- Fixing lengths based on fastening through the trough of the panel
- Various coloured caps available
- Selected lengths are available with or without washer. (16mm washer for wall applications and 19mm washer for roof application)
KS1000 RW fixing to steel substrate 4.0 - 12.0mm
- Fixing lengths based on fastening through the trough of the panel
- Various coloured caps available
- Selected lengths are available with or without washer. (16mm washer for wall applications and 19mm washer for roof application)
KS1000 RW fixing for metal flashing to panel
- Various coloured caps available
KS1000 RW side lap stitcher
- Various coloured caps available
Installation instructions1
NOTE: Failure to abide by these instructions may void any warranty provided by Evolution Fasteners (UK) Ltd. This document does not alleviate the user, designer or any other party from their respective obligations under the terms of the Warranty2. The use of impact tooling voids the Warranty.
- Clear installation area of dirt and debris and ensure that there are no other contaminating substances (i.e. oil, grease, etc),
- Using a non‐impacting TEK screwdriver (such as Makita FS2500), insert the screw into the fixture and substrate material perpendicularly (± 5˚ from the normal) using not greater than 1,500 RPM and a steady pressure on the tooling only (do not force the tool, allow the screw to cut),
- Stop inserting the screw once the underside of the flange makes contact with the topside of the fixture material for non‐washered screws. For washered screws continue inserting until the compression disc of the washer changes from convex to flat. There should be no torque applied to the fasteners post‐installation.
Disclaimer:
This document is provided for educational purposes only and remains the intellectual property of Evolution Fasteners (UK) Ltd. The information provided in this document does not alleviate any responsibility on the part of any third party, nor does Evolution Fasteners (UK) Ltd accept any liability for any failures in practice, design or otherwise by any third parties using this document. Evolution Fasteners (UK) Ltd retain all rights in relation to this document. This document shall not be reproduced except in full, without written approval from Evolution Fasteners (UK) Ltd. Whilst every effort was made to ensure that all information in this document is accurate, it is provided strictly on the basis errors and omissions excepted. It is the recommendation of Evolution Fasteners (UK) Ltd that any third party seeking to use our products should enquire directly with the Evolution Technical Department either by e‐mail to technical@evofas.com or phone call to +44 (0) 141 647 7100. Written enquires can be made to:
Technical Department and Laboratory Services
Evolution Fasteners (UK) Ltd
Clyde Gateway Trade Park
Dalmarnock Road
Glasgow G73 1AN
United Kingdom
1Video instructions available on our YouTube™ channel (Evolution Technical Services and Laboratory)
2For further information, refer to the Evolution Product Warranty document hosted on our website.
Evolution fasteners
Copyright 2019
All rights reserved